Cisco 675 Question

Dejan Nikic yu_music at hotmail.com
Thu Jul 26 16:09:16 PDT 2001


Well its been a long time since I did anything on Cisco routers but there is
a way to flash the memory somewhere in there. Look in the help section
untill you find something to flash it.

Man, I just wish I could remember where it was, but the last time i saw a
Cisco router was like 2 years ago.




>From: Richard Lotz <rlotz at u.washington.edu>

>Reply-To: linux at u.washington.edu

>To: UW Linux Group <linux at u.washington.edu>

>Subject: RE: Cisco 675 Question

>Date: Thu, 26 Jul 2001 15:27:44 -0700 (PDT)

>

>A stab in the darkHrm...have you tried `write all` rather than just

>`write`?

>

>-richard

>

>On Thu, 26 Jul 2001, WebMasterP wrote:

>

> > sorry to say, but you're way off base :D

> >

> > You have to be in enable mode to do any of the commands we are talking

> > about.

> >

> > there is exec and enable mode, you start out in exec, then you type in

> > enable to set nat entries

> >

> > goes like this

> > password

> > enable

> > password

> > set nat entry delete all

> > write

> > reboot

> >

> > and then they all come back.

> > I'm pretty sure that's the same problem the orginal guy is having.

> >

> > Regards,

> > Dan Podhola

> > Web Master

> > http://www.autoadvisor.com

> >

> > -----Original Message-----

> > From: LINUX-owner at u.washington.edu

> > [mailto:LINUX-owner at u.washington.edu]On Behalf Of Matt Holland

> > Sent: Thursday, July 26, 2001 2:46 PM

> > To: UW Linux Group

> > Subject: Re: Cisco 675 Question

> >

> >

> > I faintly remember having to go into something called "enable mode" for

> > writes to nvram to take effect. Look into that, it might be the problem

> > you're having.

> >

> > -matt

> >

> >

> > on 7/26/01 2:37 PM, Greg Daly at gdaly at u.washington.edu was heard to

>say:

> >

> > > Hey all,

> > > I have a cisco 675 that I recently upgraded to cbos 2.4.1. I set some

> > static

> > > NAT entries up for a while, and then i didnt need them anymore. The

>only

> > > problem is, when I reboot or reset the cisco they come back.

> > > I have tried

> > >

> > > set nat entry delete all

> > > write

> > > show nat

> > >

> > > and they are gone, but upon reboot, they come back.

> > > any ideas?

> > > thanks,

> > > -greg

> > >

> >

> > --

> > Matt Holland

> > Network Administrator

> > FCB Seattle

> > 206.628.3645

> > http://seattle.fcb.com

> >

> >

> >

>



_________________________________________________________________
Get your FREE download of MSN Explorer at http://explorer.msn.com/intl.asp



More information about the Linux mailing list