Cisco 675 Question

Russell Power rjpower at washington.edu
Fri Jul 27 20:46:33 PDT 2001


Though I have never encountered this problem with my own 675 the site Zach
described does have some interesting information - I found it at:

http://www.users.qwest.net/~rlutton/ADSL/

You can find information on resetting the configuration under the Misc. Info
section.

--russell

----- Original Message -----
From: "Z. Frazier" <zfrazier at u.washington.edu>
To: "UW Linux Group" <linux at u.washington.edu>
Sent: Friday, July 27, 2001 5:34 PM
Subject: Re: Cisco 675 Question



> i used to have a cisco 675,

>

> if you log in on the serial console and issue a break as it is booting or

> right after, you will get a prompt at which you can type "ES 6" , this

> will erase page number 6 of the memory...

>

> this however may go to far, as it cleans all of your NVRAM, passwords, and

> config file. great for a fast and dirty fix...

>

> i think you enter "MO" or "monitor off" or something similar next. then

> "go" should reboot the modem to a clean out of the box state.

>

> i remeber finding this a while go on somebodys personal homepage hosted by

> Qwest. In fact there tech support said they couildn't help me, but sent

> me to the page of a customer...

>

> -zach

>

> Zach Frazier

> zfrazier at u.washington.edu

>

> On Thu, 26 Jul 2001, Greg Daly wrote:

>

> > Hey all,

> > I have a cisco 675 that I recently upgraded to cbos 2.4.1. I set some

static

> > NAT entries up for a while, and then i didnt need them anymore. The only

> > problem is, when I reboot or reset the cisco they come back.

> > I have tried

> >

> > set nat entry delete all

> > write

> > show nat

> >

> > and they are gone, but upon reboot, they come back.

> > any ideas?

> > thanks,

> > -greg

> >

> >

>

>




More information about the Linux mailing list